Nonlinear finite elements/Nonlinearities in solid mechanics

Nonlinearity is natural in physical problems. In fact the linear assumptions we make are only valid in special circumstances and usually involve some measure of "smallness", for example, small strains, small displacements, small rotations, small changes in temperature, and so on.

We use linear approximations not because they are more correct but because

• Linear solutions are easier to compute.
• The computational cost is smaller.
• Solutions can be superposed on each other.

However, linear analysis is not adequate and nonlinear analysis is necessary when

• Designing high performance components.
• Establishing the causes of failure.
• Simulating true material behavior.
• Trying to gain a better understanding of physical phenomena.

The choice of analysis depends on the problem at hand. The usual questions an engineer asks when deciding on the type of analysis to perform are

• What is the goal of the analysis?
• What are the acceptable amounts of error?

A cost-benefit analysis is usually necessary before embarking on the nonlinear analysis of a problem.

Types of Nonlinearity

Nonlinearities are classified into three major types:

1. Geometric nonlinearities.
2. Material nonlinearities.
3. Contact nonlinearities.

Geometric nonlinearities

Geometric nonlinearities involve nonlinearities in kinematic quantities such as the strain-displacement relations in solids. Such nonlinearities can occur due to large displacements, large strains, large rotations, and so on. Contact can also be classified as a geometric nonlinearity because the area of contact is a function of the deformation (some authors puts contact in another class called nonlinear boundary conditions).

An example of a problem that involves a geometric nonlinearity is the torsional spring problem (see Figure 1).

File:TorsionSpring.png Figure 1. A bar attached to a torsional spring.

We want to find the relationship between the rotation $\theta$ of the bar and the applied force $F$.

A balance of moments on the bar gives us

$M=Fl\cos \theta$

where $M$ is the moment at the pinned end of the bar.

We can relate the moment $M$ to the rotation of the spring by the constitutive equation for a torsional spring

$M=k_T\theta$

where $k_T$ is the torsional spring constant.

Therefore, we can write

$F=\frac{k_T\theta }{l\cos \theta }(\text{nonlinear in}\theta ).$

If the angular displacement $\theta$ is small (i.e., $\theta \to 0$), we have $\cos \theta \to 1$. Therefore, the force-rotation relationship becomes

$F=\frac{k_T\theta }{l}(\text{linear in}\theta ).$

Figure 2 shows how the linear approximation compares with the nonlinear solution. The nonlinear and linear solutions are quite different beyond a rotation of around 30 degrees.

File:TorsionSpringSol.png Figure 2. Forces-rotation relationship for a bar attached to a torsional spring.

Material nonlinearities

Material nonlinearities occur when the stress-strain or force-displacement law is not linear, or when material properties change with the applied loads.

For the torsional spring, we can introduce material nonlinearities if we assume that the constitutive equation for the spring is

$M=(k_0+k_1\theta )\theta .$

In that case, the force-rotation relation becomes

$F=\frac{(k_0+k_1\theta )\theta }{l\cos \theta }(\text{both material and geometric nonlinearity}).$

If we assume small rotations, we get

$F=\frac{(k_0+k_1\theta )\theta }{l}(\text{only material nonlinearity}).$

Figure 3 shows how the inclusion of material nonlinearities affects the solution.

File:TorsionSpringSolMGNL.png Figure 3. Forces-rotation relationship for a bar attached to a torsional spring (with material and geometric nonlinearities).